Twiflex多福GMR系列盤式制動卡鉗| Twiflex 

Twiflex多福GMR和GMR40系列盤式制動卡鉗分別適用于25.4毫米和40毫米厚的盤式制動卡鉗。閥瓣直徑為610毫米。 

Twiflex多福通常每個磁盤使用一個或兩個卡尺，但數量可以根據磁盤大小而增加。Twiflex多福制動器可以以任何角度放置在閥瓣周圍，水平安裝(即在3點鐘或9點鐘位置)。如果卡尺安裝角度大于10°從水平，或在垂直軸應用，它應該安裝一個傾斜安裝組件。一系列的制動盤可從Twiflex(參閱盤和轂組件)。 

對于氣動操作，使用干燥、過濾和非潤滑的壓縮空氣。氣動制動器需要一個控制閥，可以手動操作，也可以通過氣動或電信號操作。 

在圖表上顯示的額定值是基于完全鋪設和條件剎車片與公稱摩擦系數μ = 0.4。Twiflex盤式制動器必須使用Twiflex石棉無剎車片。 

Twiflex多福盤式制動器有效圓盤半徑=實際半徑(m) - 0.06m。

GMR Series Disc Brake Caliper | Twiflex

The Twiflex GMR and GMR40 series of disc brake calipers is suitable for use with discs of 25.4mm, and 40mm thick respectively. Minimum disc diameter is 610mm.

Normally one or two calipers are used per disc, but the number may be increased depending on disc size. The brakes may be positioned at any angle around the periphery of the disc, but should ideally be mounted horizontally (i.e. at the 3 o’clock or 9 o’clock position). If the caliper mounting angle is greater than 10° from the horizontal, or on vertical shaft applications, it should be fitted with an inclined mounting kit. A range of brake discs is available from Twiflex (see Disc and Hub Assemblies).

For pneumatic operation use dry, filtered and non-lubricated compressed air. Pneumatic brakes require a control valve, operated either manually or by pneumatic or electrical signal.

The ratings shown on the graphs are based on fully bedded in and conditioned brake pads with a nominal friction coefficient μ = 0.4. Twiflex disc brakes must be used with Twiflex asbestos free brake pads.

Effective disc radius = actual radius (m) – 0.06m.